C:\fakepath\pump-out.jpg

Pumping Out

If your boat has a holding tank, learning to use a pumpout station is a necessary part of your boat's operation. This is an area where a small mistake can lead to a big mess, so take your time and be careful.

This video will walk you through the steps of using a pumpout station.

Or you can follow the steps below.

How To Pump Your Boat's Holding Tank:

Since different machines vary slightly, be sure to read and follow posted directions! In general, here's how it works:

Step 1:  Remove cap from boat's deck waste fitting.

 pump_step1.jpg

Step 2:  Insert pumpout hose nozzle into deck fitting.

pump_step2.jpg 

Step 3:  Turn pump on. If there is a hose valve, open it to start the suction.

pump_step3.jpg 

Step 4:  When no waste is seen in sight glass, close hose valve and remove nozzle from deck fitting.

pump_step4.jpg 

Step 5:  Put nozzle (with open valve) in bucket of water for 15 seconds to rinse hose. If desired, rinse boat's holding tank with water and pump dry.

pump_step5.jpg 

Step 6:  Close valve. Put away hose. Turn off pump if requested. Replace deck fitting cap.

pump_step6.jpg